This is a special limited time offer of the 5 Gallon bucket of International Coatings 7014 Legacy White Plastisol Ink. This limited time offer is the same trusted ink your shop can rely on, at a reduced cost saving you over 70 dollars off the traditional pricing. This low a low bleed, high pigment, is a fast ashing, low tack, non phthalate plastisol screen printing ink. This ink has a cream viscosity medium body, making the ink suitable for auto and manual presses. This ink offers superior performance through fast production speeds, and its brightness and opacity.
INSTRUCTIONS FOR HANDLING & USAGE:
7014 Legacy White is a low bleed ink, not a non-bleed ink. On some types of fabric, bleeding or dye migration may occur. Always test print the fabric to be printed before beginning production. It is best to do some long term testing on fabrics to determine if they are going to bleed. Bleeding or dye migration may not occur right away. Adding any reducers or additives can lower bleed resistance, reduce opacity, or increase cure times of the ink. STIR the ink prior to printing on press and after addition of reducers or additives. Test dryer temperatures and wash test printed product before and during a production run.
Opaque Matte finish
Fast-flashing with minimal tack
Prints through fine meshes
Easily printed on manual or automatic presses
Spot Flashing With International Coatings 7014 Legacy White Plastisol Ink :
International Coatings 7014 Legacy White Plastisol Ink will spot dry with a very low after flack tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused. Totally fusing the underprint white may cause inter-coat adhesion problems with the inks printed on top of the white ink. Final fusing or curing occur in the dryer.
Additional information For International Coatings 7014 Legacy White Plastisol Ink:
7014 Legacy White, compared to other opaque whites, prints more easily. You will find that a finer screen mesh can be used the same opacity as a more open mesh. This means less ink will be needed, a real money saver in terms of ink usage. It also means a softer hand on ashed fabrics.
Technical Specifications of International Coatings 7014 Legacy White Plastisol Ink:
Fabric Types: 100% cotton, 50/50 cotton/poly blends, some polyesters
Mesh: Count: 60 - 230 t/in (24 - 90 t/cm) Monofilament
Squeegee: Durometer: 65-75, Sharp Edge
Flash & Cure Temperatures: 325º F (163º C) for 1 minute, Dependent on dryer speed and temperature settings.
Storage: 65-90°F (18-32°C) Avoid direct sunlight. Keep container well sealed.
Clean Up: Any Eco Friendly plastisol screen wash.