International Coatings 901LF Nylon White Ink is a fast flashing, 2 part plastisol based ink, specifically formulated for printing on normally hard to print nylon. This product is the 5 Gallon size container of ink. This ink has been an industry leader for over 10 years. As easy to use as a conventional plastisol and just as durable.
INSTRUCTIONS FOR HANDLING & USAGE:
International Coatings 901LF Nylon White Ink must be mixed with the 900 catalyst before printing. Catalyst is provided in 2 oz. and oz. containers should be thoroughly hand stirred into the ink. Ink may be used immediately after mixing. Do not mix more ink than is needed for a job. Do not under catalyze the ink. Pot life of mixed ink 4 to 8 hours. Over catalyzation will shorten pot life of ink.
Hand stir catalyst for International Coatings 901LF Nylon White Ink:
1 oz. Catalyst: 1 Pint Of Ink
2 oz. Catalyst: 1 Quart Of Ink
3 oz. Catalyst: 1 Gallon Of Ink
Additional information For International Coatings 901LF Nylon White Ink:
If necessary ink may be thinned with 1% to 5% by volume, of mineral spirits or 1% to 5% by volume of 1110 Curable Reducer. It is important not to use reducers that are 100% plasticizer, because they may decrease adhesion and make the finished ink film less durable.
Technical Specifications of International Coatings 901LF Nylon White Ink:
Fabric Types: Nylon, Cotton and some cotton/polyester blends. Always test print fabric for adhesion before beginning a production run.
Mesh: Count: 60 - 305 t/in (24 - 120 t/cm) Monofilament
Squeegee: Durometer: 70-80, Sharp Edge
Flash & Cure Temperatures: 300°F to 325°F (149°C to 163°C) entire ink film. Test dryer temperatures.
Storage: 65-90°F (18-32°C) Avoid direct sunlight. Keep container well sealed.
Clean Up: Any Eco Friendly plastisol screen wash or mineral spirits.