Home page
Need help with your order?

Item Detail

IC904GL
International Coatings 904LF Nylon Scarlet Red Ink - 1 GL (Catalyst Not Included)
Manufacturer Item:
Quantity Available: 3 GL
Sell Price: $71.00 GL
Next Quantity Break: 0
Next Quantity Break Discount: $0.00
Extended Price: $71.00
GL

 Extended Descriptions
 

APPLICATIONS

International Coatings 904LF Nylon Scarlet Red Ink is a fast flashing, 2 part plastisol based ink, specifically formulated for printing on normally hard to print nylon. When it comes to hard to print nylon, the 900 series inks are recognized as the industry's best. 900 series inks are a fast flashing, two-part ink system specifically formulated for printing on nylon. They are as easy to use as conventional plastisols and just as durable. This product is a 1 Gallon size container of ink. This ink has been an industry leader for over 10 years. As easy to use as a conventional plastisol and just as durable.


INSTRUCTIONS FOR HANDLING & USAGE:

Do not under catalyze the ink. Pot life of mixed ink 4 to 8 hours. Over catalyzation will shorten pot life of ink. International Coatings 904LF Nylon Scarlet Red Ink must be mixed with the 900 catalyst before printing. Catalyst is provided in 2 oz. and oz. containers should be thoroughly hand stirred into the ink. Ink may be used immediately after mixing. Do not mix more ink than is needed for a job.


Additional information For International Coatings 904LF Nylon Scarlet Red Ink:

If necessary International Coatings 904LF Nylon Scarlet Red Ink may be thinned with 1% to 5% by volume, of mineral spirits or 1% to 5% by volume of 1110 Curable Reducer. It is important not to use reducers that are 100% plasticizer, because they may decrease adhesion and make the finished ink film less durable.


Hand stir catalyst for International Coatings 904LF Nylon Scarlet Red Ink:

  • 1 oz. Catalyst: 1 Pint Of Ink

  • 2 oz. Catalyst: 1 Quart Of Ink

  • 3 oz. Catalyst: 1 Gallon Of Ink  


Technical Specifications of International Coatings 904LF Nylon Scarlet Red Ink:

Fabric Types: Nylon, Cotton and some cotton/polyester blends. Always test print fabric for adhesion before beginning a production run.

Mesh: Count: 60 - 305 t/in (24 - 120 t/cm) Monofilament

Squeegee: Durometer: 70-80, Sharp Edge

Flash & Cure Temperatures: 300°F to 325°F (149°C to 163°C) entire ink film. Test dryer temperatures.

Storage: 65-90°F (18-32°C) Avoid direct sunlight. Keep container well sealed.

Clean Up: Any Eco Friendly plastisol screen wash or mineral spirits.


 Warehouses
 
Warehouse Description Quantity Avail
10 Garston-East Hartford 3 GL
20 Garston-Haverhill 0 GL
30 Garston-Rochester 0 GL
#

Line Item Add

Item Number:
Quantity:
Unit of Measure: