International Coatings 931LF Nylon Fluorescent Pink Ink is a fast flashing, 2 part plastisol based ink, specifically formulated for printing on normally hard to print nylon. This product is the 5 Gallon size container of ink. This ink has been an industry leader for over 10 years. As easy to use as a conventional plastisol and just as durable.
INSTRUCTIONS FOR HANDLING & USAGE:
Catalyst is provided in 2 oz. and oz. containers should be thoroughly hand stirred into the ink. Ink may be used immediately after mixing. Do not mix more ink than is needed for a job. Do not under catalyze the ink. Pot life of mixed ink 4 to 8 hours. Over catalyzation will shorten pot life of ink. International Coatings 931LF Nylon Fluorescent Pink Ink must be mixed with the 900 catalyst before printing.
Additional information For International Coatings 931LF Nylon Fluorescent Pink Ink:
It is important not to use reducers that are 100% plasticizer, because they may decrease adhesion and make the finished ink film less durable. If necessary ink may be thinned with 1% to 5% by volume, of mineral spirits or 1% to 5% by volume of 1110 Curable Reducer.
Hand stir catalyst for International Coatings 931LF Nylon Fluorescent Pink Ink:
1 oz. Catalyst: 1 Pint Of Ink
2 oz. Catalyst: 1 Quart Of Ink
3 oz. Catalyst: 1 Gallon Of Ink
Technical Specifications of International Coatings 931LF Nylon Fluorescent Pink Ink:
Fabric Types: Nylon, Cotton and some cotton/polyester blends. Always test print fabric for adhesion before beginning a production run.
Mesh: Count: 60 - 305 t/in (24 - 120 t/cm) Monofilament
Squeegee: Durometer: 70-80, Sharp Edge
Flash & Cure Temperatures: 300°F to 325°F (149°C to 163°C) entire ink film. Test dryer temperatures.
Storage: 65-90°F (18-32°C) Avoid direct sunlight. Keep container well sealed.Clean Up: Any Eco Friendly plastisol screen wash or mineral spirits.